Grasshopper

algorithmic modeling for Rhino

Orient Perp frames, sweep

Hello,

I want to apply a profile by a sweep.

I have several curves input on which I apply a perp frames. Those curves are not on the same plane. But an offset of each curve (meaning the original and the offset are on the same plane) should allow me to set the orientation of perp frames by the offset direction vector.

Then I am trying to set those vectors from 2 parallel lines and use it for the orientation plane.

I can't use a specific orientation angle due to the random orientation lines.

I need help, thanks

Views: 1350

Attachments:

Replies to This Discussion

Permalink Reply by Andrei Raducanu on May 31, 2013 at 4:12pm

i had the same problem and solved it right now. im my case i have curves that are in vertical planes, which helps, but i'll try to make it more global and upload it if you want

Permalink Reply by JBL on June 13, 2013 at 8:35am

Have you solved the problem with random curves? That would be helpful. Thanks

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service