Grasshopper

algorithmic modeling for Rhino

offet / loft

Hi,

I would like to offet a curve and then create a loft between that that curve and the original curve. very simple, I thought the attached would work, but form some reason it doesn't ... any ideas?
thanks,
Peter

Views: 178

Attachments:

Replies to This Discussion

Permalink Reply by Vicente Soler on August 21, 2009 at 7:10pm
The offset component creates a new sub branch for the resulting curves, so they are in a different path than the original. Right click on the 'S' input of the loft component and select 'flatten'.
Permalink Reply by peter on August 22, 2009 at 3:47am
thanks :)

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service