Grasshopper

algorithmic modeling for Rhino

Need help to planarize surfaces (with Kangaroo)

Hi all, I'm a beginner to Grasshopper and Kangaroo. I'm trying to planarize the following surfaces with the same logic to How to create planar Honeycomb Shells using Kangaroo. But an error message says that I don't have enough points for a polyline.

Each surface is tilting at a certain angle that's why they are not planar - that is based on another script I did earlier. Is there are way to make them planar while keeping the gaps in between as small as possible?

Thanks in advance!

Views: 2466

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on April 2, 2017 at 11:58am

Hi.

Take a look at the attachment. You'll need K2.

Attachments:
Permalink Reply by Natalie on April 2, 2017 at 8:13pm

Thanks for your reply!

But when I'm trying to use the same script on the second half of the model, the surfaces cannot be planarized. Do you know any solutions for that?

Permalink Reply by Hyungsoo Kim on April 3, 2017 at 9:34am

Check this. You should keep the valence of line segment numbers and points.

Attachments:
Permalink Reply by Natalie on April 4, 2017 at 7:47pm

Thank you so much!! Will test around with the script!

Permalink Reply by luna cagnoni on September 14, 2017 at 10:27am

Could someone please help me to planarize this attachement? thanks in advance! 

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service