Grasshopper

algorithmic modeling for Rhino

NE1 Help with this one please!

What I´m trying to make this time, would be divided in the next steps:
1) Put a cone (geo) inside a B.box.
2) Divide a sphere in U=30 segments and V=30 segments.
3) Make B.Boxes on all those segments.
4) Array the cones all around the sphere (BUT I WANT THE CONES TO FLOW WITH THE SURFACE AS IF THE CENTER OF EACH b.bOX IS POINTING TO THE CENTER OF THE SPHERE).


To accomplish what you see above, I made an array of the cone over a quarter sphere (surface),using the next definition:

Views: 791

Attachments:

Replies to This Discussion

Permalink Reply by Dirk Anderson on June 19, 2009 at 11:33pm
Try this BBox Morph of a circle and then extrude to centre by vector length.

Attachments:
Permalink Reply by Federico Escobar Salas on June 20, 2009 at 10:34am
Very cool outcome! Thanks!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service