Multiply planes

Replies to This Discussion

Permalink Reply by Peter kluck on November 20, 2010 at 5:04pm

Permalink Reply by David Rutten on November 20, 2010 at 5:14pm

Sure, just use the Plane Offset component and any number of offset values.

If you want a mathematical offset, you can also generate the offset distances using a Range or Series component (perhaps combined with an Expression or Graph Mapper object).

--
David Rutten
david@mcneel.com
Seattle, WA

Permalink Reply by Dragos Babeanu on November 20, 2010 at 5:26pm

Thanks a lot guys I just found a few minutes ago a video here on this website that had almost the same solution.I am trying to do this for a few hours now :)) And the solutions was such a easy one... :D What I am trying to do is the Foster's Erotic Gherkin.Hope will make it to the finish...
Thanks again

Permalink Reply by Dragos Babeanu on November 20, 2010 at 5:59pm

Hi,
One more question.I would like to know how is it possible to unite the points on the surface with the "Curve on Surface command" so that each time u go up a row the point u unite with; is on one position to the left.
Cheers

Attachments:

• 3D.JPG, 215 KB
• Scheme.JPG, 116 KB

Permalink Reply by David Rutten on November 20, 2010 at 6:39pm

Does the attached do what you need?

--
David Rutten
david@mcneel.com
Seattle, WA

Attachments:

• ShiftFlipConnect.ghx, 117 KB

Permalink Reply by Dragos Babeanu on November 21, 2010 at 3:11am

That's exactly what I needed.Thanks a lot man.I am not used yet to how the list and the matrixes function yet cause I saw they are one of the most important components in GH.
Cheers

Permalink Reply by Dragos Babeanu on November 21, 2010 at 3:15am

There is this small question I would like to ask.what difference does it make when you set "Graft" for an input parameter?