multi curves offset!

Replies to This Discussion

Permalink Reply by Chris Tietjen on February 13, 2011 at 2:28pm

Curve item #11 is messed up... but I don't know why.

Chris 

 

 

Permalink Reply by Andrew Heumann on February 13, 2011 at 2:58pm

You've got a duplicate point in the curve that's getting screwed up. Turn on edit control points, highlight a point in the upper corner, delete, and you're good to go.

Permalink Reply by Andrew Heumann on February 13, 2011 at 3:04pm

if you have kangaroo there's also a GH solution, in case this occurs again and you don't know where the trouble point is:

 

Permalink Reply by RWNB on February 14, 2011 at 4:11am

ok, in my case the offset problems
have something to do with the points.
But why it fails here?
there are two similar cases.
an answer would be super.

many thanks

 

Attachments:

• Offset_01.3dm, 49 KB
• offset_01.ghx, 278 KB

Permalink Reply by Dedackelzucht on February 14, 2011 at 11:27am

Hey,

 

once I had a aimilar problem with a voronoi geo.

 

Check your 3dm if everything is absolutly in same z Koordinates..B

 

 

R Johannes