Grasshopper

algorithmic modeling for Rhino

Moving control points of a curve

Hello,

first off sorry if this is probably a very entry level problem but, I have an issue about control points.

I made up a definition where a set of points (which I can move using sliders) creates a set of curves. 

But what I would like to do is to manually adjust my curves through control points too (not only with the "parametric" set of points controlled by sliders). 

The fact is when I try to do that I can only edit the control points by baking the curves.

Is there any other way?

Thank you

Views: 5932

Replies to This Discussion

Permalink Reply by djordje on November 25, 2012 at 6:43pm

Hi Daily,

Maybe something like this?

That purple block with value sliders (called "Gene list") can be used instead of couple of number slider.

Attachments:
Permalink Reply by Daily Brian on November 25, 2012 at 6:57pm

Hiya, thanks for your reply and for the definition.

I'll give it a try in my def and I'll let you know!

thank you

Permalink Reply by Daily Brian on November 25, 2012 at 7:13pm

I tried it works wonders thank you so much !!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service