Grasshopper

algorithmic modeling for Rhino

meshes and mesh settings

maybe this is a dumb question and hope i am not the first one to ask it:
i cant find a mesh from surface component, so i guess gh cant create meshes from nurbs surfs.
what are the mesh settings components used for then?

Views: 1672

Replies to This Discussion

Permalink Reply by Pep Tornabell on March 29, 2010 at 10:15am
In mesh components... you will find it, otherwise you can subdivide surface and build mesh through vertices... (but looking carefully I think you will find it) MeshBrep sounds nice... MeshSurface... even better

(make sure you have the last GH version instaled (WIP))

Good luck
Permalink Reply by roberto gagliano on March 29, 2010 at 12:41pm
MeshBrep did it.
thanks!
Permalink Reply by Nik Willmore on August 16, 2015 at 6:07pm

NITMSTINM = "not in the manual since there is no manual."

Thanks for being the living manual, five years later. Found it again. I guess it was in the same menu grouping and that was the clue I missed.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service