Grasshopper

algorithmic modeling for Rhino

MESH Won't Relax with Weaverbird and Kangaroo

Hi,

I am trying to create a curve ceiling using this kangoroo&weaver bird script that i download from Daniel Piker. I create the edge surfaces and change to mesh but it will not relax using the definition. I am trying to create a curve ceiling according to deformation height of the grid. Can somebody please help me to figure it out? I want those mesh in the picture relax.

Thank you,

Andrew

Views: 549

Replies to This Discussion

Permalink Reply by Daniel Piker on December 6, 2012 at 5:29pm

It's because your input mesh has some problems

I fixed them through a combination of AlignMeshVertices, Weld, UnifyMeshNormals, RebuildMesh and ReduceMesh.

Some of these problems can be avoided by carefully choosing the meshing settings

(it works best if you have fairly equal edge lengths, and no intersecting faces or non-manifold edges)

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service