algorithmic modeling for Rhino
Merge data into different branches of the same tree
It's a newbie here, don't be too hard on me.
Is this possible through an easy yet unknown way?
I've found my way (in the attached ghx), thanks to the component "Assign Paths" by Andrew Heumann (http://parametricmodel.com/AssignPaths/39.html), but I believe there has to be an easier yet not so obvious way.
Views: 910
- Attachments:
-
-
Merge into branches.ghx, 395 KB
-
Replies to This Discussion
-
Permalink Reply by Álvaro Ollero on
-
By the way, I've also found my way like this, but it just doesn't seem easy enough to me.
-
About
Welcome to
Grasshopper
Translate
Search
Photos
Videos
-
Ngon Mesh
Added by Parametric House 1 Comment 0 Likes
-
Minimal Surface
Added by Parametric House 0 Comments 0 Likes
-
Wind Pavilion
Added by Parametric House 0 Comments 0 Likes
© 2026 Created by Scott Davidson.
Powered by
