Grasshopper

algorithmic modeling for Rhino

Make curved wall and be able to control curvature of it

I want to take this square grid wall with the extrusions and make it a curved will, sort of wavy. But I want to be able to control how much it curves. I attached an image of a curved line that I want the wall to look like form the top view. However, like I said, I want to be able to control how much it's curved in both areas. How can I do this?

Thank you.

Views: 749

Attachments:

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on November 12, 2016 at 6:55am

Try "Jackalope" plug-in's "Flow" component. Best.

Attachments:
Permalink Reply by Amanda Lucia on November 13, 2016 at 3:48pm

thanks

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service