Grasshopper

algorithmic modeling for Rhino

Lofting and grafting problem

Hello everyone, 

I'm following a proposed exercise from Arturo Tedeschi's AAD, it's in the 'advanced data management' chapter at page 226.

I have to create a frame onto a surface. I can get everything right until the lofting part, which gives me a null result. I checked multiple times and the script seems to be the same exact one as that in the book.

Does anyone know why it does not work?

Views: 309

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on February 23, 2017 at 6:08am

Hi.

The "offset on surface" is not working properly in the area where your reference surface is too twisted and narrowed. That's why the null curves were generated.

You'd better decide whether to fix the original design or not.

Attachments:
Permalink Reply by A CP on February 23, 2017 at 8:31am

Got it thank you! 

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service