Grasshopper

algorithmic modeling for Rhino

Loft with holes

Hi everybody

Im trying to make a loft surface with holes.

I have some cercles and that i would like to use it like holes in the loft.

Can somebody help me please?

Thanks a lot!

Nico

Views: 716

Attachments:

Replies to This Discussion

Permalink Reply by Joseph Oster on March 15, 2017 at 8:15am

I had to sort the curves by their start points to get them in sequence for 'Loft'.  Then 'Project' holes unto surface and feed them ('Flattened'!) to 'SrfSplit'.  Then sort the three resulting surfaces by area; the largest one is shown, the holes are not.

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service