Loft trouble :)

Replies to This Discussion

Permalink Reply by Andrew Heumann on February 10, 2016 at 10:50am

Loft is the wrong tool for this job - it only works with sequential sections (connect A to B, B to C, C to D, etc). Try patch instead - it will try to fit a surface through all your 3d curves. you may need to draw a few additional curves to get the geometric result you're looking for.

Permalink Reply by Mia on February 14, 2016 at 2:35pm

Thanks Andrew! I was thinking, that loft is not a good idea . I tried patch and is much better. I need to just optimize some curves.