Grasshopper

algorithmic modeling for Rhino

loft problems between 2 trees

hey everyone!
I want to make up a loft between sets of curves:

{0} with {0}

{1] with {1}

...

{9] with {9}

the problem is that i need to shift the branches in my tree because somehow (throug previous operations) my branches don't seem to be in the same order, that means that i would need to loft {0} with {1},  {1} with {2},...{8} with {0}!
is there a way how i can reorder the branches in a way that i can finally loft as i described in the beginning:

{0} with {0}

{1] with {1}

...

{9] with {9}

thanks in advance!

Views: 696

Attachments:

Replies to This Discussion

Permalink Reply by °[u on December 18, 2013 at 2:24pm

Hi,

could it be that you are searching for the "Relative Item" Component?

Attachments:
Permalink Reply by maxk on December 19, 2013 at 5:43am

thanks! it did help!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service