Grasshopper

algorithmic modeling for Rhino

Loft component

Hi all

Im trying to make an object in which I need to loft the lines between the two circle (Attached Image).

The problem is that when I connect the lines to loft component there is always one line which is not lofted.

I tried to make the model simple so that it will be easier to read.

Thanks 

Views: 600

Attachments:

Replies to This Discussion

Permalink Reply by Antony Chiha on May 23, 2013 at 2:14am

If you right click on the options for the loft component and tick the mark for closed loft, it should take care of the problem

Permalink Reply by Tigerpix on May 23, 2013 at 8:31am

Thanks very much, its all good now.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service