Grasshopper

algorithmic modeling for Rhino

Hi guys!

I am facing one problem here. I am sure you guys can help me.

                       20

                    19   18

                  17  16  15

               14  13  12  11

             10  9   8   7    6

           5    4     3   2  1  0  

I am triangulating this surface. I want to select just the red vertices. As you can note, I just need the inner vertices of this surface. I could do it mannually, but if I want to change the mesh density later, I will have to pick all of them manually again later.

Can someone help me? 

Tks

Views: 288

Attachments:

Replies to This Discussion

Can you guarantee that the mesh vertices will always be so nicely ordered? Because if not you'll need to take a geometric approach. If however you need to generate the lists {1,2,3,4}{7,8,9}{12,13}{16} then there's lots of ways of doing that.

Attachments:

tks a lot David! It worked.

I tried with different number divisions, and they worked properly. It seems that the order is always the same.

tks again!

RSS

About

Translate

Search

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service