Grasshopper

algorithmic modeling for Rhino

Kangaroo not deleting duplicate points

I'm trying to generate lines originating from the points, but since the points come from a split surface, I have many duplicate points. I tried using removeDuplicatePts but it barely removes 2 points with the default tolerance, and when I change it, it deletes useful points. 

Any way I can cull the duplicate points? 

Views: 1209

Attachments:

Replies to This Discussion

Permalink Reply by Daniel Piker on May 15, 2013 at 4:00am
It's because your points are in different paths. If you flatten the list before feeding into the remove duplicates component then it will remove all duplicates across the tree.
Permalink Reply by Ignacio España on May 15, 2013 at 8:05am

Thanks a lot, that solved quite a few problems :D

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service