Grasshopper

algorithmic modeling for Rhino

folding pattern

I have been trying to make a folding pattern using hinges from kangaroo to achieve the image a href="https://storage.ning.com/topology/rest/1.0/file/get/2654882516?profile=original" target="_self">1.png 

The hinge at the first step doesn't seem to be working when i set the timer on at kangaroo physics. I have set all the points for the hinges, not sure where the script is going wrong? any help will be greatly appreciated 

Views: 1441

Attachments:

Replies to This Discussion

Permalink Reply by Andrei on January 3, 2015 at 12:10pm

Hello,

It seems to be working fine when I run it, can you elaborate a little on what it is that you are expecting to happen?

Best reagrds

Andrei

Permalink Reply by gule ser on January 4, 2015 at 2:48am

thank you andrei for replying, i got it to work in the end as well, I think there was something wrong with my grasshopper program, it didn't run it

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service