Grasshopper

algorithmic modeling for Rhino

Joining Surfaces

Im having some trouble trying to combine these trimmed surfaces. They are all flat on exactly the same plane. I just need it as a single slightly strange surface, including all the voids.

 

Thanks

Views: 3616

Replies to This Discussion

Permalink Reply by David Rutten on July 21, 2011 at 5:29am

Hi Nick,

 

if there was a component that did the MergeAllFaces thing it could be done (albeit very slowly). I had to put that function into a VB script as it stands.

 

 

I'll add a MergeFaces component for the next release. Also note that I extracted the correct face by trial and error. What you should do is test the vertices of the individual faces and filter out the one face that lies entirely on the WorldXY plane.

 

--

David Rutten

david@mcneel.com

Poprad, Slovakia

Permalink Reply by Nick Tyrer on July 21, 2011 at 9:53am
ahhh ok well i can do it manually. Thanks

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service