Grasshopper

algorithmic modeling for Rhino

Usually when I build a surface in rhino and divide up the UVs with Isotrim in GH it matches my rhino model as long as i have the same UV values. For some reason it is not working here, I am trying to get my UVs to fall on the same location as the rhino surface so that my panels will fall on the horizontal floor slab lines. I made the rhino surface as a network surface, not sure if this is the problem. Any help or a work around would be greatly appreciated.   

 

Views: 798

Replies to This Discussion

some attachments would probably help

I figured out away around it, I ended up projecting horizontal lines onto the surface which match the spacing of the floor slabs, I then divide the lines equally and flip the matrix while shifting a lists, so that the points generate sub divisions that match the same logic as the iso-trim component. Now the surface is essentially re-built with subdivisions that can be controlled horizontally to match the floor slabs by whatever spacing is needed.

 

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service