Grasshopper

algorithmic modeling for Rhino

Isocurve_Steps

Hello all!

I made this definition and would like to change the isocurve divisions.

Actually they have the same gap but I want some different gaps. I managed to get

the isocurves I was looking for but I don't know how I can connect them with the

surfacemorph. Do you have any suggestion?

Views: 903

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on November 2, 2017 at 11:41am

Something like this?

Take a look at the attached.

Attachments:
Permalink Reply by Hyungsoo Kim on November 2, 2017 at 11:49am

Permalink Reply by Joseph Oster on November 2, 2017 at 11:54am

Attachments:
Permalink Reply by Lorenz Weiss on November 3, 2017 at 1:35am

Hey, thanks a lot to both of you!

I think the second one is easier but I will try to understand both.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service