algorithmic modeling for Rhino
Hi,
I'm trying to curve a diamond/triangular ribbon (doesn't need to be a smooth curve) using hinges. I was envisioning that one end of the ribbon would have anchor points and the rest would slowly curve upwards. I've looked on other discussions of this forum, but can't see a solution so far. I'm new to the hinge tool and think I have set it up correctly, but probably not because there is no movement at all!
I would appreciate any help.
GH file attached.
Thank-you!
Tags:
Welcome to
Grasshopper
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson. Powered by