algorithmic modeling for Rhino
intersection untrimmed surfaces
hallo,
my goal is to get an overall similar wide gap inbetween the faces of this brep.
so if i explode the brep and use the curves together with pipe then the outcome will be a overall similar wide object as untrimmed surfaces. but how am i able to intersect or work with any kind of boolean operation with the untrimmed surfaces from the explode brep to cut the overlap away?
thx.
Views: 1141
- Attachments:
Replies to This Discussion
-
Permalink Reply by Danny Boyes on
-
What about using the Offset on Srf component.
-
-
Permalink Reply by Sebastian D Kriegsmann on
-
nice, it worked out…
thx.
is there then a possibility to unroll these surfaces to laser cut them?
-
-
-
As these are planar surfaces you could use the Orient Component to array the surfaces on the cplane.
There is a lot of wastage in this particular example. You could look into something like RhinoNest to reduce this.
- Attachments:
-
-
lasercutarray.gh, 11 KB
-
-
About
Welcome to
Grasshopper
Translate
Search
Photos
Videos
-
Mesh Anchors
Added by Parametric House 0 Comments 0 Likes
-
Parameric Roof
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson.
Powered by
