Grasshopper

algorithmic modeling for Rhino

Individually Adjusting Points/Corners of a polygon

Hi Everyone,

I am new to Grasshopper but enjoying learning. I have been trying to achieve the following:

  • A Hexagon/Polygon where I can manually adjust each point/corner to define its x & y coordinates using sliders.
  • Assigning a Fillet Radius to individual corners of the hexagon but not all of them.

Just wanting to know if it would be possible to achieve the above, I would like to adjust each corner individually resulting with a somewhat distorted hexagon.

Would be grateful if anyone could point me in the right direction,

Thanks

Views: 447

Replies to This Discussion

Permalink Reply by Jay Smith on December 8, 2014 at 10:36pm

This is where I'm up to, I have the Irregular hexagon but want to add a fillet to individual corners...

Attachments:
Permalink Reply by Eli on December 12, 2018 at 4:32pm

Did you get anywhere with this? Would be great to see something with this level of adjustability on a 3 dimensional shape.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service