Grasshopper

algorithmic modeling for Rhino

Increased UV Count is adding unwanted Geometry

Hi everybody

i modeled some basic geometry in grasshopper.

By increasing the number for the V Count of the lofted surface

additional geometry is added to my basic geometry.

I am not sure why this is happening and how to achieve the result I am after shown

in the attached file.

I would appreciate if someone could lead me into the right direction.


Thank you for any assistance!!!!!

Views: 584

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on March 3, 2016 at 12:54am

Hi. Findie.

See red parts. You shouldn't have flattened Evalute Curve's "p" output.

Attachments:
Permalink Reply by Findie on March 3, 2016 at 1:26am

Hi Hyungsoo
thank you!!!
You made my day :)

Can i ask you why you added
flip and reparameterize
cause it works just fine without flattening the evaluate Input ???

Permalink Reply by Hyungsoo Kim on March 3, 2016 at 1:41am

reparameterize---> fix curve domain 0 to 1 regardless of it's length.

Flip---> for unifing surface nomal direction

Permalink Reply by Findie on March 3, 2016 at 7:06am

Thank you for clarifying!!!!

helped me a lot to get a better understanding.

Permalink Reply by O Loos on March 3, 2016 at 9:50am

Hi

As Hyungsoo said, basically when your items are matched with those in different branches. Thas a datatree issue. I guess next time you can figure it out easily by this principle.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service