Grasshopper

algorithmic modeling for Rhino

im lost

hello! I need to be able to get something like this picture, being able to move both ground hiles in both ways, and being able to add as much hiles así I need keeping it growing and going higher. I also need to be able to control the move on Z being able to make it higher or lower. any clue? thanks 

Views: 311

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on April 4, 2017 at 5:35pm

See your previous post.

Permalink Reply by Anders Holden Deleuran on April 5, 2017 at 1:21am

RSS

About


McNeel Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2026   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service