Grasshopper

algorithmic modeling for Rhino

How can I affect the length of an element in the BoxMorph?

Hi everyone. 

I've created geometry that is dependent on a slider controlled arch span. I've then BoxMorph-ed that geometry onto a series of points. 

How can I then control the above span based on the distance from those points to some other point?

Please see attached files...

Views: 225

Attachments:

Replies to This Discussion

Permalink Reply by Daniel Dirscherl on October 14, 2013 at 2:13pm

Nevermind... I figured it out.

I used NU Scale with a scale factor derived from (desired length/original span)

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service