How can connecting Box Morph to Brep

Replies to This Discussion

Permalink Reply by Danny Boyes on July 11, 2012 at 3:14am

You don't need the IsoTrim Component.

SBox will do the same thing by creating a box on the supplied domains of the original surface. By introducing the extra step you are no longer supplying the corresponding domains of the new sub-surfaces.

Permalink Reply by Shahab Din on July 11, 2012 at 7:47pm

Thanks Danny for discussion. But I don't understand, can I connect a box morph to Brep for make a Mesh or not. Because I need connecting this models to DIVA for analyzing the daylight.

Permalink Reply by Danny Boyes on July 12, 2012 at 12:12am

yes. i cannot post any example at the moment but from what i can tell looking at you image you have one component that is causing the error in the definition. the isotrim, which is the component in middle at the bottom.

remove this and connect the input surface directly to the sbox component instead of the surface output from isotrim.

Permalink Reply by Shahab Din on July 13, 2012 at 3:28am

Danny,I already edited last modeling ( show in image1 ) bout I can't connected a Box Morph to Brep Or Mesh( image2) .Let me know what can I do ?????

Peace

Shahab

 

Permalink Reply by Danny Boyes on July 13, 2012 at 3:55am

Is see what you are getting at now. For future reference it would be easier to work with the same files as you rather than just the screen shots.

The message you can see is a group not a Brep and Not a Mesh. To get the Breps out of the Group you need to use the Un-Group Component 

Permalink Reply by Shahab Din on July 15, 2012 at 6:00pm

Thanks a lot Danny, I have change the Group to Join Brep.That is working.

Peace

Shahab