Grasshopper

algorithmic modeling for Rhino

Help with organizing list items

Hello

   I set up a definition to project a point onto the xy plane and then create a cone shaped loft based on some section curves. everything works well until I get more than one input point. how should I change this definition so that it creates a new loft for each input point?

Views: 352

Attachments:

Replies to This Discussion

Permalink Reply by David Rutten on May 23, 2014 at 2:57am

Step 1. Upload the GH file so we don't have to recreate it from pixels.

--

David Rutten

david@mcneel.com

Permalink Reply by Danny Boyes on May 23, 2014 at 3:44am

Somethings I don't get about the definition as it is in the image but nether the less the solution to your question is "<Graft> the [Point Param]"

Permalink Reply by limbatus on May 23, 2014 at 10:36am

thanks for the response. I think my definition is now obsolete after seeing the post above. What component is that after the 3 Circle CNRs?

Attachments:
Permalink Reply by David Rutten on May 24, 2014 at 2:25am

Merge

--

David Rutten

david@mcneel.com

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service