Grasshopper

algorithmic modeling for Rhino

help! triangulated mesh required

i've made a continuous surface of triangulation out of delaunay edges and now i gotta give them surfaces. was wondering if any of you have any advice on this given the the curves arent defined as triangles. the intent is to maintain the irregularity of pattern.

thanks!

 

Views: 756

Attachments:

Replies to This Discussion

Permalink Reply by Nicolaus Wright on May 2, 2011 at 1:10am

Use DelMesh rather than DelEdge.  DelMesh outputs a full mesh, which you can also decompose and operate on all the faces.

 

Btw, how did you get it to wrap around on itself without connecting across?

Permalink Reply by wesley.s on May 2, 2011 at 3:55am
i designed the triangulation on a planar surface, then projected it on to a curved surface using box morph. . .not sure delaunay mesh will do the same trick and project the mesh in that shape and form

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service