Grasshopper

algorithmic modeling for Rhino

Help ! Orienting geometry tangent to surface

Hello,

I made a surface, divided it and set squares on each division placed on their center. I would like to orient these squares tangent to the surface. It's frustrating because there is a normal component in surface divide but i can't figure out how to get the squares to be oriented tangent to the surface even though i can display all the vectors... Maybe my whole method is wrong, any tips or help would be greatly appreciated !  Here is my file and a pic :

Thanks

Views: 1345

Replies to This Discussion

Permalink Reply by Jacob Peel on October 16, 2016 at 10:36pm

You just have to use the Orient component and feed it the Rectangle, a Reference Plane and a Target Plane

Attachments:
Permalink Reply by Nicholas Sandquist on November 6, 2016 at 2:47am

sorry for the late reply, thank you very much !

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service