HELP for surface connections

Hi everybody,

I am new to Grasshopper and I tried to design a vase. It is a very simple design. The file is in the attachment. In my design, there are gaps at the bottom of the vase and between two surfaces at the top of the vase. How can we fill these gaps at Grasshopper. Or should we bake the model and solve the problem at Rhino.

Attachments:

vase trial.gh, 14 KB

Replies to This Discussion

Permalink Reply by phillip on July 17, 2013 at 3:05am

Extract the edges. [Loft] the upper ones together and [PlanarSurface] works for each of the lower ones.

Permalink Reply by phillip on July 17, 2013 at 3:25am

p.s.: I have never seen a bake-the-model-and-solve-the-problem-in-Rhino-solution in here.If so, check that the adress to the website is correct.

Permalink Reply by Homer Garcia Santana on July 17, 2013 at 3:24am

Well it depent on the wished outcome...here is another option...

Permalink Reply by Yenal Akgün on July 17, 2013 at 5:40am

Thank you Homer for the "cap holes" component. For the top of the vase, if I want to have a fillet-like finishing, how can I do it? I mean, at your solution the top of the vase is sharp, but I want it circular?

Could I explain it. Should I use "arc"?

Thank you again

Permalink Reply by Danny Boyes on July 17, 2013 at 4:21am