Grasshopper

algorithmic modeling for Rhino

Hello, I have a line direction problem.

Hello. I have a question about making some rafter stuffs in rhino and grasshopper

I made a base line for rafter arrangement, then used a definition to make thickness.

But, the problem is that some rafters shows discordance in their directions as a screenshot shows below.

I want to make it to be aligned in a same direction. ( as it is shown, rafters should be 50X200, but some are oriented in a different direction like 200X50 )

Can anyone tell me the way to solve the problem?

I attached the rhino and gh file.

Views: 604

Attachments:

Replies to This Discussion

Permalink Reply by Dedackelzucht on September 26, 2012 at 1:19am

Hey I do not get really why you do it this way. Some components you use are not needed. I made a defenition in the way I would solve this problem.

Best Regards

DeDackel

Attachments:
Permalink Reply by Namhyuck Ahn on September 26, 2012 at 5:35am

Thanks DeDackel! It really works better. I have not enough knowledge about it since I'm a starter in grasshopper, anyway, it's helpful !

 

With Regards

Namhyuck Ahn

Permalink Reply by Dedackelzucht on September 26, 2012 at 6:37am

Ask if you do not understand something I did!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service