Grasshopper

algorithmic modeling for Rhino

Hi,

I am looking to make a series of planar surfaces from curves cut from a BREP. Most of the Plane-BREP intersections work fine but some result in curves which are slightly out of plane (eg xxx e-13).

 

Does anyone know a way to either change the tolerance so making the planar surface from this slightly out of plane curve won't fail or to "flatten" the curve onto a specified plane?

 

Thanks

 

Kermin

Views: 4123

Replies to This Discussion

You could use the Project component, and then Planarsrf

RSS

About

Translate

Search

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service