Grasshopper

algorithmic modeling for Rhino

find valid uv domain for trimmed surface in GH

Sometimes trimmed surfaces are hard to avoid. In order to work with them I'd like to know the trimlines or trimcurves in the uv domain.

If there is no obvious way, can I somehow remap the trimmed surface edges into the uv domain? 

Big Thanks,

Stefan

Views: 594

Replies to This Discussion

Permalink Reply by Daniel González Abalde on September 27, 2017 at 4:14am

this?

Attachments:
Permalink Reply by Stefan Knorr on September 27, 2017 at 4:32am

Thanks Daniel.

The upper version with the uvP output seem suitable for me.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service