Grasshopper

algorithmic modeling for Rhino

Hello everyone,


I am in a terrible mess.
I have to draw some structural steel plates to connect a lot of irregulars beams

My problem is how to fillet the surface to make them adjacent.

I've been trying for days ;(

Views: 3572

Attachments:

Replies to This Discussion

No solutions!!??

please!

the grasshopper file

Attachments:

Extract curves - loft
Luck.

Attachments:

thank you for your replay!!

but i need a real filled with the possibility to choose a ray of fillet.

something more like the attached image

Attachments:

I dont understand what exactly you need. Extruded parts from the big piece I think would improve your definition, especially to adjust the parties.

Attachments:

Thank you very much Dani for your prompt replay and your help!
That is what I was looking for!!!


You're right there were too many breps! I corrected them.

But, does not exist in Grasshopper a symple way to fillet surface together as in Rhino??

so I could extrude and give a thickness after fillet parties

best wishes for happy holidays!

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service