Grasshopper

algorithmic modeling for Rhino

extrude in both side

Hi, still learning grasshopper, I would need to find a way to extrude a plane in both directions.
Thus, I would like the center point of my plane to remain the center point of the created brep.
thanks for any help.
Thibaut

Views: 4573

Replies to This Discussion

Permalink Reply by Danny Boyes on September 18, 2010 at 2:41am
you would have to extrude first by x amount and then move the brep back by -x/2
Permalink Reply by tib ctrl on September 18, 2010 at 1:04pm
thanks for the tip.
(I thought I was missing an extruding option component..)
Permalink Reply by paulcoudamy on May 18, 2012 at 10:58am

Hello,

I've the same problem but to extrude a solide from a curve bothside like the rhino tool : solid/extrudecurv/straight/bothside

Is anyone have a tip ?

thank you

Paul

Permalink Reply by MARIO VERGARA on May 18, 2012 at 11:40am

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service