[Solved] ExportToOpenStudio vs runEnergySimulation - Results differences

Hi,

I'm performing thermal comfort analysis for some project.

I'm trying to migrate from using the runEnergySimulation component to exportToOpenStudio as recommended by Chris.

Comparing the results from using the same setting for both options i get different results. So i'm assuming that the exportToOpenStudio is adding additional default values. Otherwise i can't explain the differences, that sometimes are significant.

Attached a couple of images showing the issue.

Thanks,

-A.

Attachments:

runEnergySimulation.JPG, 138 KB
exportToOpenStudio.JPG, 142 KB

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Abraham Yezioro on October 23, 2016 at 10:05pm

OK,

This is official. Issue solved == case closed.

Results are exactly the same.

Thanks a lot. This was a tough one.

-A.

Permalink Reply by Mostapha Sadeghipour Roudsari on October 23, 2016 at 10:09pm

Great job both! As always impressed by both of you, on finding the issues and get them fixed. I hope to finally break out of the butterfly strike in the next few days and check this out.