"exception was thrown during a solution" error help~~

I have a surface geometry with many subsurfaces offsetted in to little grids, for some time now, it has been working slowly but surely, however, it started to give up on me in the last hour without me having changed anything. I'm getting "exception was thrown during a solution" errors for where I need to convert the curves to surfaces. Is this just the RAM getting tired? What can I do to solve it?

Thank you in advance to any advice!

Attachments:

help.PNG, 6 KB
help2.PNG, 16 KB
help3.PNG, 45 KB

Replies to This Discussion

Permalink Reply by David Rutten on August 3, 2016 at 10:10am

Any hope of getting a rough translation of those Asiatic characters that presumably describe the problem?

Permalink Reply by Ying Xu on August 3, 2016 at 5:30pm

Thank you for responding David! I'm not so good at reading it, but it says something like "The object reference cannot be set to become object instance."

Permalink Reply by David Rutten on August 4, 2016 at 12:12am

Ok, I know what that means. I'll have a dig though that component code to see what could be causing it.

Permalink Reply by Ying Xu on August 4, 2016 at 1:05am

Thank you so much David, sorry for the trouble. I resorted to skipping the offset(L) so that it isn't converting back and forth between curve and surface (which a TA had just advised me I shouldn't be doing anyway - that although sometimes curve directly fed into surface works... it shouldn't?) So since this problem is avoided now for my purpose, it isn't a pressing situation anymore =) It would be great for the source of the issue to be found, but please do so at your convenience, thank you again!

RSS