Error using Mesh Maschine

Hello everyone,

I wanted to use the mesh machine component to smoothen and to redefine a mesh which is quite complex, because it is a 3d scan. As I did so, a runaway face circulator and/or runaway vertex circulator error occurred.

So I tried it with a simple sphere and one of daniels definitions to get it right, but there was no change.

The error does not occur always. just after setting the toggle to false and then to true again, the error disappeared without changing any other parameters. then I toggled again and until this very moment I can't get rid of the error again. 

I would appreciate any help!

I had very good experiences withe the mesh machine before, but somehow I can't find my mistake.

Thanks!!