Grasshopper

algorithmic modeling for Rhino

ecotect does not analyse mesh properly, bizarre result

Hi I am trying to analyse a surface/mesh using ecotec. i have done this before and it has worked fine, however for the following one I cant seem to get it to work....and when it done it has a bizarre result that is not actually of my mesh.

Check out the images and see...

Thank you

Views: 363

Attachments:

Replies to This Discussion

Permalink Reply by Arthur Mamou-Mani on November 25, 2012 at 1:25pm

Hi Sarah,

You need to join your mesh faces before exporting the mesh to ecotect.

Use "Join Mesh" and then plug the resulting mesh to EcoMeshExport.

Hope this works.

Best,

A

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service