Grasshopper

algorithmic modeling for Rhino

drape curves on surface

I am looking for a way to drape a 2D collection of curves onto group of contour surfaces. "Project curves" works however the curves are projected to all surfaces where as I need the to only project to the visible surface area from the "top' view.

The goal is to project 2D site data to a the 3D contour surfaces which will then be laser cut (no point laser etching the data to an area which isn't going to be visible once the model is put together)

I am new to Rhino and grasshopper so I'm not sure if grasshopper is the best way to solve this problem, but I feel this feature would be Incredibly useful! (especially for large scale projects)

Thanks!!

Views: 1855

Attachments:

Replies to This Discussion

Permalink Reply by Alex on June 1, 2014 at 9:58am

Hi, Patrick! Did You find the solution? Also have the same problem... Thank You

Permalink Reply by Patrick Scott on June 1, 2014 at 5:58pm
Hi Alex, no I never found a way to do it. Hopefully someone on here knows. In the end I had to trim all the lines manually
Permalink Reply by Alex on June 1, 2014 at 10:06pm
Thank You for Your reply.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service