Grasshopper

algorithmic modeling for Rhino

Welcome colleagues

Can you please tell how to determine the angles between the lines forming the space frame, and specify the color mapping of the angle if the angle is provided, for example, less than 40 degrees between lines.

Views: 3236

Attachments:

Replies are closed for this discussion.

Replies to This Discussion

Can you post a file that doesn't require Panelling Tools components? Perhaps just internalise or bake the geometry you wish to measure.

David, Yes of course replace the file in the theme.

Nah it still contains a plugin component I don't have.

But if you want to show all the angles between adjacent edges in a mesh, you can take the following approach:

Attachments:

David, thank you very much for your reply

I use the lunchbox plugin. Angles to the grid is clear how to do, I do not know how to make the angle of lines intersecting at a single point in space.

Attachments:

Hi David,

thank you for your post. I wrote a very similar definition in the past. But what I needed were the angle values as numbers. To check if there are some angels under a specified threshold. I had to do a huge work around to get them. I was wondering if there is a way to add an Output Parameter to the Dimension Components?

colleagues,
Is it possible to show that both corners in the spatial structure and show tsvvetom angles less than 50 degrees for example??

paneling tools http://www.grasshopper3d.com/group/panelingtools

Attachments:

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service