curving tubes along surface

Replies to This Discussion

Permalink Reply by lucas cañada on December 9, 2011 at 5:09pm

http://www.grasshopper3d.com/forum/topics/one-more-push-before-the

See this discussion, think will help you ;)

Permalink Reply by Jissi Choi on December 10, 2011 at 3:32pm

 

Here are two solutions..

 

One is very simple..

 

I used Frames of Surface for the base plane of circles rather than Points..

 

So, it has circles along the surface but still planar curves.. (because they are circles..)

 

 

The other uses Projected Curves..

 

So I removed boundaries on which projected curves are not closed..

 

 

 

 

 

 

Attachments:

• Answer.gh, 42 KB