Grasshopper

algorithmic modeling for Rhino

Curve subdivision in unequal steps

Hello everybody,

is it possible to change the step of the dividing curve component for each curve?

For example:

I have a loft between two arcs (like a tube). The created surface is filled with frames in u and v direction.

These points are connected by lines. I want to divide each curve in (one direction) from the surface's highest point down to the zero point in segments. But the lower the curves' position is, the less it should divided.

For example: The highest curve should be divided into 10 segments. The next curve, which position is a little bit lower should be divided into 10/2=5 Segments. The next curve should then be divided into 5/2 segments and so on and so on.

I hope you can help. PLEASE

Thanking you in anticipation!!!

Best greetings. Phil

Views: 556

Replies to This Discussion

Permalink Reply by nikos tzar on November 22, 2014 at 7:08am

Hi Philipp,

posting your file would help.

Nikos

Permalink Reply by Valentin on November 22, 2014 at 8:07am

its example

Permalink Reply by Philipp S on November 22, 2014 at 9:38am

The attachment contains the grasshopper file but also an image how it may be should look like in the end.

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service