Grasshopper

algorithmic modeling for Rhino

Curve or spline with more than 3 points

Hello everyone, I want to make a curve from multiple points ( more than 3).

I have lots of curves with points comes from graphs on X direction. I want to make curves with the points of graph based curves, on Y direction. There are 2 jpegs, first is our graph based curves, at next jpeg, I made lines between this curves. All in all, I want to make curves or splines instead of lines on jpeg.

Views: 1541

Replies to This Discussion

Permalink Reply by David Rutten on April 23, 2014 at 8:18am

Flip Matrix is your new best friend.

--

David Rutten

david@mcneel.com

Attachments:
Permalink Reply by Fth D on April 23, 2014 at 8:39am

Thanks a lot, but my curves created with grasshopper to manipulate them later. So I can't use "Set Multiple Curves", need transform them to one curve.

Attachments:
Permalink Reply by David Rutten on April 23, 2014 at 10:03am

It doesn't matter where the curves come from. The divide component will work whether the curves were picked from Rhino or generated in GH.

--

David Rutten

david@mcneel.com

Permalink Reply by David Rutten on April 23, 2014 at 10:20am

--

David Rutten

david@mcneel.com

Attachments:
Permalink Reply by Fth D on April 23, 2014 at 11:32am

I am a newbie to Grasshopper and this is exactly what I need.

Thank you again.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service