Grasshopper

algorithmic modeling for Rhino

Curve Offset not Effected by Crv Dir?

I am not seeing the curve direction effecting whether the offset is inside or outside like it always has.

Did something change with the new Rhino WIP?

I tried to open Grasshopper in V4 just to test a simple offset but I am getting the attached error.
thanks.




Views: 189

Attachments:

Replies to This Discussion

Permalink Reply by David Rutten on October 22, 2010 at 2:13pm
Hi ryles,

sorry I haven't responded to this yet. I'm pretty busy at the moment with a large upcoming trip and the 0.8 release. I'm shirking a lot of support duties at the moment.

I'll try and get around to this when my schedule has freed up somewhat, but feel free to post again if anything fails to materialize soon enough.

--
David Rutten
david@mcneel.com
Poprad, Slovakia

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service