Grasshopper

algorithmic modeling for Rhino

Curve join problem

Hi Everyone,

I am trying to create a "pinch" on opposite sides of my tower. I am having trouble with one side of the tower where two edges are not joining together to make a smooth curve.

I want the "pinch" to run all the way through to the top of the tower, similar to the image attached. I would appreciate if someone could help me, Thanks.

Views: 491

Attachments:

Replies to This Discussion

Permalink Reply by Ethan on January 18, 2015 at 9:34pm

:) 

Attachments:
Permalink Reply by Jay Smith on January 18, 2015 at 10:15pm

Thanks for your help Ethan! All because of that one point, how annoying haha

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service