Grasshopper

algorithmic modeling for Rhino

Curve/Curve Intersection problems

Hello David,

Have a question regarding the behavior of Curve/Curve (CCX) component.

Some times it solves the intersection of Lines (Coming from SDL), sometimes it doesn't at all or solves them partially.

Can't really identify the when. It seems to be completely random.

Any ideas on that erratic behavior?

Thanks,

Dimitris

Views: 369

Replies to This Discussion

Permalink Reply by David Rutten on July 24, 2014 at 2:57pm

Can you upload some geometry that fails to produce the correct intersections?

--

David Rutten

david@mcneel.com

Permalink Reply by Dimitrios Papadopoulos on July 24, 2014 at 3:40pm

David,

I apologize.

I figured it out.

It works fine. I got completely confused for a while.

Thanks,

Dimitris

Permalink Reply by David Rutten on July 24, 2014 at 3:43pm

No problem. I get confused a lot, I know what it's like :)

--

David Rutten

david@mcneel.com

Permalink Reply by Dimitrios Papadopoulos on July 24, 2014 at 3:48pm

:)))

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service